Cold Extrusion Rebar Couplers for Mechanical Splicing

Cold Extrusion Rebar Couplers

Cold extrusion rebar couplers connect reinforcing bars by hydraulic pressing, providing a strong mechanical splice without threading or welding.

Cold extrusion rebar couplers are mechanical sleeves used to join two reinforcing bars end-to-end. The steel sleeve is pressed onto the rebar using a hydraulic extrusion tool, creating a secure mechanical connection. No rebar threading or welding is required.

Key Benefits

  • No threading or welding required
  • Suitable for standard ribbed rebar
  • Fast on-site installation
  • Helps reduce rebar congestion compared with lap splicing
  • Suitable for repair work and confined construction areas
  • Can be used for tension and compression connections
  • Provides a traceable mechanical connection when properly specified and installed

Mechanical couplers are commonly used where lap splices are impractical, such as with large-diameter rebar, tight reinforcement zones, or tension members. They can also reduce steel overlap and congestion in reinforced-concrete work.

Installation Steps

  1. Clean and straighten the two rebar ends.
  2. Mark the required insertion depth on each rebar.
  3. Insert the first rebar halfway into the cold extrusion coupler.
  4. Use the correct hydraulic press and dies to extrude the sleeve from the center toward the end.
  5. Insert the second rebar until both bar ends meet at the center.
  6. Extrude the second side according to the required pressing sequence.
  7. Check the finished connection, pressing marks, dimensions, and alignment.

The exact pressing pattern, hydraulic pressure, die size, and inspection criteria must follow the supplier’s approved technical instructions for the specific coupler size and rebar grade.

Typical Applications

  • High-rise buildings
  • Precast concrete structures
  • Columns and shear walls
  • Beams and foundations
  • Bridges and infrastructure
  • Piles and retaining structures
  • Rebar repair and extension work

Important Note

Select the coupler based on rebar diameter, rebar grade, design load, project standard, and required joint-performance class. Use calibrated hydraulic equipment and trained operators. A cold extrusion coupler should not be mixed with unverified rebar sizes, dies, or installation procedures.

  • Bolt Rebar Couplers
  • One-Touch Rebar Couplers
  • Straight Thread Rebar Couplers
  • Steel Grout Sleeves
  • Half Grouted Sleeves
  • Reinforcement Drive Pipes

Contact Us

Send us your rebar diameter, steel grade, project standard, required quantity, and destination port. We can recommend suitable cold extrusion rebar couplers, hydraulic pressing tools, and matching dies for your project.

Newsletter Updates

Enter your email address below and subscribe to our newsletter